Note: There are seat width restrictions on most scooter and power chair models. Before ordering, please read the Specs tab for further information.
If you need a new Jazzy or Jet power chair seat, then our 24" x 20" deluxe contour vinyl seat base will work on most Jazzy and Jet models, as well as many of the standard size Pride Mobility scooters.
How to measure your seat:
Measuring Usable Seat Depth-- Refer to Figures 1 and 2
1. Position a carpenter's square in the middle of the seat as shown.
2. Slide the square back until it just makes contact with the seat back. Keep the horizontal section of the square parallel with the floor. This will allow for contours and cushioning bolsters.
3. Measure the distance between points
A and
C. This measurement is the seat's usable seat depth.
Measuring Usable Seat Width-- Refer to Figure 2
1. Measure 4-1/2" from point
A to find line
B-D.
2. Measure the distance between
B and D. This measurement is the usable seat width.
Our power chair seat base units are genuine Pride Mobility replacement parts. Monster Scooter Parts is an authorized dealer of genuine Pride parts, so you can be sure that our Jazzy, Jet, Quantum, and Pride scooter and power chair parts are the best available.
In addition; many Pride scooters, as well as Jazzy and Jet power chairs have a maximum recommended seat size that should not be exceeded. The Specs tab above contains a list of the Pride, Jazzy and Jet power chair and scooter models with sizing restrictions and the maximum seat dimensions.
In order to ensure the correct fit, we strongly encourage you to read our
Mobility Seat Measuring Guide before ordering any Pride or Jazzy replacement seat or any other seating components.
⚠ WARNING California Residents:
Proposition 65 Warning