Cart 0 Cart

Keypad with Actuator Buttons for the 5 Key Dynamic Shark DK-REMD11 and MK5 SPJ+ Joystick

Invacare
SKU: P49-9088
PaceSaver: 82675
Pride Mobility: PLSINDV1265

Keypad with Actuator Buttons for the 5 Key Dynamic Shark DK-REMD11 and MK5 SPJ+ Joystick

Invacare
SKU: P49-9088
PaceSaver: 82675
Pride Mobility: PLSINDV1265
$49.99
  • Replacement keypad for the 5 key Dynamic Shark DK-REMD11 joystick remote
  • The 5-key Dynamic Shark is used on the Jazzy 614 and several PaceSaver power chair models
  • 30 Day Warranty
View full description
Checking status...
Checking status...

Description

Replacement keypad for the 5 key Dynamic Shark DK-REMD11 joystick remote. The 5-key Dynamic Shark is used on the Jazzy 614 and several PaceSaver power chair models. This part is sometimes referred to as a joystick overlay.

Also used on the Invacare MK5 SPJ+ "with accessories" joysticks.

Please check the Compatibility tab for a listing of known compatible models.

Installation Instructions:
1. Ensure the wheelchair power is turned off.
2. Pull the gray collar back and disconnect the joystick cable from the joystick.
3. Peel up and remove the existing, damaged keypad from the joystick face plate.
4. Inspect the joystick contacts, face plate, and joystick housing for corrosion and/or damage.5. Using an alcohol prep pad, remove any adhesive from the joystick face plate.
6. Ensure no adhesive remains around the rim of the joystick face plate.
7. Gently remove any adhesive that may have collected in the lighting or contact cutouts of the joystick face plate.
8. After cleaning, set the joystick aside for ten minutes to allow all alcohol to evaporate from the joystick face plate.
9. Inspect once more for adhesive lumps or residue. If necessary, repeat steps 5-8 to clean the joystick face again if adhesive is present.
10. Remove the backing from the new keypad.
11. Align the bottom edge of the keypad with the bottom edge of the joystick face plate. Ensure the keypad is properly aligned with the joystick face plate before installing. The overlay is not repositionable.
12. Working from the bottom up, gently press the keypad completely into the joystick face plate.
13. Firmly press the keypad into the joystick face plate ensuring proper seal between the adhesive and joystick face plate.
14. Ensure the keypad is completely seated into the joystick face plate and no air pockets or ripples are present around the edge of the keypad.
15. Connect the joystick cable to the joystick.
16. Turn on wheelchair power and test the joystick functions.
17. If the joystick does not function properly, you may have a faulty joystick.

Invacare pert number: 1165093

⚠ WARNING California Residents: Proposition 65 Warning