36 Volt 1000W Universal Speed & Voltage Controller

36 Volt 1000 Watt universal voltage/speed controller for electric scooters, bikes, go karts, and mopeds.

Six connectors: Battery, Motor, Charger, Lock, Hall Throttle, and Brake.

You MAY need to cut and splice a few but not all of your old controller connectors.

Compatible with most 36 Volt products equipped with 600-1000 Watt motors.

This controller uses a 3 wire throttle. Not compatible with 4 wire or Currie 5-pin or 6-pin half grip throttles.

SPECIFICATIONS:
Voltage: 36 Volts
Current: 28 Amps maximum

Known Compatibility:

X-Treme XP-700

Other makes and models requiring 36V 1000W controllers!

Controller connections as follows:

Battery Connector (Black & Red Wires, Thick)
Battery wiring. Same as OEM connector. Connect to your battery's connector. Black to Black, Red to Red.

Motor Connector (Blue & Yellow Wires, Thick)
Motor wiring. May be the same as the OEM connector, or may require cutting and splicing. Cut and splice (if necessary) to your existing controller motor connector or hard wire to your product’s wiring. Blue (controller) to Blue or Red or Orange (existing wiring), Yellow (controller) to Brown or Black or Green (existing wiring).

Indicator Connector (Black and Red Wires, Thin)
Battery charger connector, may be the same as the OEM connector, or may require cutting and splicing. Connect to your product’s “charge” connector.

Power Locks Connector (Blue & Red Wires, Thin)
Key switch connector, may be the same as the OEM connector, or may require cutting and splicing. Connect to your product’s “lock” connector, or hard wire to your keyswitch wiring.

To Put Connector (Red, Black, & Blue Wires, Thin)
Hand throttle connector, 3-wire. Plug your 3-wire hand throttle wires into the three prongs on this connector. Black to Black, Red to Red, Blue to the third wire on your hand throttle (Blue or Green or other). Your product's throttle wiring may be included in the existing 6 pin connector on your wiring harness.

Brake Connector (Black & Yellow Wires, Thin)
Brake connector, may be the same as the OEM connector, or may require cutting and splicing. Connect your product’s brake wires to this connector. Your product's brake wires may be included in the existing 6 pin connector on your wiring harness.

PLEASE NOTE:
Due to the delicate nature of voltage controllers, and the care that must be taken when making wiring connections, it is Monster Scooter Parts company policy that all voltage and speed controller sales are final. Please ensure you are comfortable making delicate wiring connections and cutting and splicing wires prior to ordering. Our entire return policy can be viewed at the link below:

Monster Scooter Parts Return Policy